Description
SMOK V8 Baby Mesh Coils: 0.15 Ohm for the TFV8 Baby Family SMOK V8 Baby Mesh coils are the 0.15Ω mesh head for the standard TFV8 Baby family of tanks. SMOK sums it up as fast heating and massive vapour, and rates it 40–80W with a best range of 60–70W. It is one of the most widely compatible sub-ohm coils SMOK has made. Two warnings before you buy. First, ‘V8 Baby’ is not ‘V8 X-Baby’ and not ‘Baby V2’ – three different coil families. Second, the TFV8 Big Baby was also sold in a TPD-compliant EU edition that takes different EU cores; if your tank is the EU edition, you need the SMOK V8 Baby Mesh EU coils instead. SMOK’s V8 Baby Mesh card: 0.15Ω, 40–80W, best 60–70W, with the tanks it fits. 🔌 SMOK V8 Baby Mesh 0.15 Ohm Coil ✔ Mesh coil ✔ 0.15Ω resistance ✔ SMOK: 40–80W, best 60–70W ✔ TFV8 Baby, Big Baby and TFV12 Baby Prince ✔ Standard (non-EU) tanks ✔ Not V8 X-Baby or Baby V2 V8 Baby Mesh vs Other V8 Baby Cores A few of the V8 Baby cores SMOK makes, with SMOK’s published ranges. Core Resistance SMOK range Best Mesh (this page) 0.15Ω 40–80W 60–70W Q2 0.4Ω 40–80W 55–65W T12 Light 0.15Ω 50–90W 60–80W X4 0.15Ω 30–70W 45–60W White Vape Co recommends: the mesh gives its best flavour at 65W . It warms up faster than the wire-built V8 Baby cores, so you can start a little lower than you would on a T12 and still get a full hit. Which Tanks Take V8 Baby Mesh Coils? SMOK prints the tanks on the coil’s own card: the TFV8 Baby, TFV8 Big Baby, TFV8 Big Baby Light Edition and TFV12 Baby Prince. Its compatibility table adds the TFV9 and TFV9 Mini tanks and the Rigel, Rigel Mini, Scar-18 and Scar-Mini kits, and SMOK’s RPM160 page says the RPM160 V9 pod accepts these coils too, under their newer ‘TFV8 Mini’ name. We don’t stock a V8 Baby tank or kit at present, so these coils are for owners. If your Big Baby is the TPD edition, the matching core is the SMOK V8 Baby Mesh EU coil or the Q2 EU core . Will not fit: the EU edition of the TFV8 Big Baby (it needs EU cores), the TFV8 X-Baby, the TFV8 Baby V2 / TFV Mini V2 or the full-size TFV8. How to Fit and Prime a V8 Baby Mesh Coil Empty the tank and unscrew it from the mod; unscrew the base from the glass section. Twist out the old coil. Clean any e-liquid pooled in the base. Wet the mesh through the side slots and drip a couple of drops down the top. Screw the new coil into the base, refit and fill through the top cap. Wait five minutes. Start at 50W and move towards 65W. How Long Does a V8 Baby Mesh Coil Last? Mesh at 60–70W with a clear e-liquid usually gives one to two weeks. It degrades more quickly with sweet flavours, and a coil that has been run dry once rarely tastes right again. SMOK gives no official figure. V8 Baby Mesh Troubleshooting Problem Likely cause and fix Won’t screw into my Big Baby Your tank is probably the EU edition. It takes EU cores. Popping and spitting Too low a wattage for mesh, or over-primed. Try 60W. Burnt after a day Fired before the cotton soaked, or run at 80W on a sweet liquid. Coil too short for the tank It’s a Baby V2 / Mini V2 tank. It needs Mini V2 coils. V8 Baby vs V8 X-Baby vs TFV Mini V2 Coils V8 Baby V8 X-Baby TFV Mini V2 Tanks TFV8 Baby, Big Baby, TFV12 Baby Prince, TFV9 TFV8 X-Baby TFV Mini V2 / TFV8 Baby V2 Pack (SMOK) Five Three Three Swap between them? No No No Best E-Liquids for V8 Baby Mesh High-VG freebase at 3mg or 6mg: a shortfill e-liquid with a nicotine shot is ideal. Mesh shows off fruit and menthol blends particularly well. Nic salts are not suited to a 0.15Ω coil at 65W. Buy V8 Baby Mesh Coils Near You Need V8 Baby coils today? Our Totton vape shop , Hythe vape shop and Holbury vape shop stock replacement pods, coils and kits, and the team can check which resistance suits your device and e-liquid. Bring your tank in if you’re not sure it’s the standard or EU edition. Stock varies by store, so give us a call before you travel. Ordering online instead? See our delivery options . You May Also Like SMOK V8 Baby Mesh EU Coils SMOK V8 Baby T12 Light Coils SMOK V8 X-Baby Q2 Coils Shortfill E-Liquids All SMOK Products Frequently Asked Questions Is the V8 Baby coil the same as the TFV8 Baby coil? Yes. ‘V8 Baby’ is SMOK’s name for the coils that go in the TFV8 Baby family of tanks. Do V8 Baby coils fit the TFV12 Baby Prince? Yes. SMOK lists the TFV12 Baby Prince on the coil’s card. What wattage for the V8 Baby Mesh? SMOK rates it 40–80W, best 60–70W. Do V8 Baby coils fit the TFV9? Yes. SMOK lists the V8 Baby coil series for the TFV9 and TFV9 Mini tanks.
