Description
🎯 3-PACK — £5.99 — 0.6Ω, 0.8Ω & 1.2Ω! Innokin Klypse V2 Replacement Pods The Innokin Klypse V2 Replacement Pods are the upgraded 2ml refillable pods for the whole Klypse family, sold as a 3-pack for £5.99 in 0.6Ω, 0.8Ω and 1.2Ω . Each pod has a built-in mesh coil, a silicone-plugged side-fill port and a magnetic base: fill, prime, vape, then swap the pod when flavour fades. V2 brings the upgraded mesh coil and reshaped mouthpiece Innokin introduced with the Innokin Klypse Plus Pod Kit , and Innokin confirms both pod generations fit every Klypse series device, from the original Klypse to the Plus. 🔥 Why the V2 Pod Matters: Independent tests ran 40 to 90ml through single pods without flavour loss — that’s 20 to 45 refills per pod from a 2ml capacity. At £5.99 for three pods, that works out at roughly £2 per pod lasting one to three weeks each. Compare that to buying a new disposable every day at £5, and the savings are obvious. Key Specs Customers Check 📦 3 Refillable Pods Per Pack One pack covers three to six weeks of daily use, depending on how hard you vape and which resistance you choose. That’s the practical reason to buy a 3-pack rather than singles. 💧 2ml Per Pod The UK legal maximum, a fifth of a 10ml bottle per fill. Refillable, so you’re not locked into one flavour per pod — fill with whatever you like, whenever you like. ⚡ 0.6Ω, 0.8Ω and 1.2Ω Options Lower numbers give warmer, airier vapour; higher numbers give a tighter, cooler draw. Pick the resistance to match your liquid and your draw style — that’s the single most important choice here. 🔋 Up to 22W (0.6Ω), 16W (0.8Ω), 12W (1.2Ω) Innokin’s published figures; kits with auto-detection set this for you. The original Klypse runs fixed at 16W, so it suits the 0.8Ω pod best . 🔥 Fixed Mesh Coil The whole pod is swapped when spent — no separate coil to buy, fit or prime. That’s the trade-off: you pay for the pod housing each time, but you never fiddle with a coil. 🏗️ PCTG Plastic Construction Tougher than standard PC, so pods survive pockets. That matters because Klypse pods are refillable — you’ll be carrying them around for weeks, not days. 🔄 Backwards Compatible V2 pods fit every Klypse kit , and original pods still fit the Plus and Pro. That means upgrading your pods doesn’t mean upgrading your device. 🧂 Nic Salt Friendly Built for 50/50 and higher-PG liquid ; 70/30 only suits the 0.6Ω. Using thick juice in a high-resistance pod causes dry hits — match the ratio to the coil. ⏳ Prime for 5 to 15 Minutes Innokin’s manual says wait at least 5 minutes after the first fill; UK reviewers suggest 10 to 15 . Skipping this is the top cause of a burnt pod — and a scorched pod never recovers. Innokin Klypse V2 Pod Specifications Specification Detail Pack Size 3 refillable pods Capacity 2ml per pod (UK TPD maximum) Resistances 0.6Ω, 0.8Ω, 1.2Ω Power Rating Up to 22W (0.6Ω), 16W (0.8Ω), 12W (1.2Ω) Coil Fixed mesh coil (whole pod replaced) Material PCTG plastic Fill Type Side fill with silicone plug Connection Magnetic base Compatibility All Klypse series devices Not Compatible With Any non-Klypse kit Prime Time 5-15 minutes before first vape Compliance UK TPD compliant Price £5.99 per 3-pack (~£2 per pod) Key Features Upgraded mesh coil: Innokin’s Klypse Pro and Plus pages credit the new pods with purer flavour and longer life. Independent tests ran 40 to 90ml through single pods without flavour loss. Backwards compatible: V2 pods fit every Klypse kit and original pods still fit the Plus and Pro. That’s genuinely useful if you own more than one Klypse device. Nic salt friendly: Built for 50/50 and higher-PG liquid; 70/30 only suits the 0.6Ω. Match the ratio to the coil or you’ll get dry hits. Prime first: Innokin’s manual says wait at least 5 minutes after the first fill; UK reviewers suggest 10 to 15. Skipping this is the top cause of a burnt pod. Refillable, not prefilled: Unlike a prefilled pod, you choose the flavour and strength every time. No waste if you change your mind mid-pod. No separate coil: The mesh coil is built in. You never buy, fit or prime a coil separately — the whole pod swaps in seconds. How Long Will One Pod Last Lifespan follows millilitres through the coil, not days: Usage Approx. Liquid Per Day Expected Duration Light vaper Around 2ml Two to three weeks per pod; 1.2Ω can reach a month Average vaper 3 to 5ml One to two weeks per pod; a 3-pack lasts about a month Heavy vaper 6ml or more Around a week, nearer five days on the 0.6Ω at full power 💷 Cost Per Week Breakdown: At £5.99 for three pods (~£2 each), an average vaper using one pod every 1-2 weeks spends roughly £1 to £2 a week on pods. Add e-liquid and you’re at £3-£5 a week against £15-£25 on disposables. That’s a saving of over £500 a year . Which Resistance Should You Choose? 💨 1.2Ω — Tightest, Coolest Draw The most liquid-efficient pod. Best with 10mg or 20mg nic salts ; Planet of the Vapes reviewers call it the natural home for bar salts. If you want a cigarette-like pull, start here. 💨 0.8Ω — The All-Rounder The original Klypse resistance and the one UK buyers praise most for flavour and leak-free reliability . Balanced MTL for 10mg salts or 6 to 12mg 50/50. This is the safest first pick if you’re unsure. 💨 0.6Ω — Warmest, Airiest Draw Warmer restricted-lung draw with the most vapour. Suits 3 to 6mg freebase or 5mg salts and copes with 70/30. Wears out soonest because it pushes the most power through the coil. 💡 Which One Should You Pick? Ex-smokers wanting a cigarette-like pull should start on 1.2Ω with 20mg salts , or 0.8Ω with 10mg if 20mg bites. Menthol switchers and long-term smokers in their 40s and 50s tend to settle on 0.8Ω . Heavy vapers coming off sub-ohm should take the 0.6Ω with a low-strength liquid from the 10ml nic salts and 50/50 e-liquids range. Compatibility and Refills Innokin’s Klypse Plus page states that the original pod and the V2 pod both work with all Klypse series devices : Device Compatible? Power Behaviour Best Pod Innokin Klypse
